WEG MOTOR AND GEAR


ELECTRO MOTOR, GEARBOX WEG MOTOR AND GEAR
0 Comments

Spread the love

Three Phase Induction Motor

Technical characteristics :
Standard NEMA MG-1
Insulation Class F
Service factor 1.15
Temperature Rise 80 K
Degree of Protection IP55
Mounting B3L(E)
Flange Without
Frame Material Cast Iron
Painting RAL 5009 203A (ISO 12944 – C3)
Bearing type 6309 C3

Helical Gear Motor

The helical gear units come in twelve housing sizes for nominal torques from 440 to 159,000 lb-in and are available in both foot and flange designs. While the two smaller gear units (C00 and C01) are able to perform to their full potential with just two stages, the larger sizes C03 to C08 are available in both two or three stages for applications in higher torque ranges. From C09 there is an additional fourth stage, while the C16 is even equipped with 5 gear stages

Parallel Shaft Geared Motors

Thanks to their structural design, parallel shaft gear units are particularly suitable for conveyor technology applications. All 11 sizes can be fitted with either a hollow shaft, output shaft, mounting flange or shrink disc. The ratio range of gear unit sizes F04 and F07 can be extended by a third, from F08 by a fourth and with size F15 even with a fifth gear stage.


Leave a Reply

Your email address will not be published. Required fields are marked *

×